Skip to content
Austin Air Conditioning Company

701 Brazos St, Austin, TX 78701

Serving Austin · Rollingwood · West Lake Hills · Lost Creek

(512) 318-9239

AC Tune Up in Austin, TX

AC tune-ups for filters, drains, wiring, and airflow in Austin.

Call (512) 318-9239 Ask a question

A technician showing a tablet to a homeowner in a living room, the two of them talking

We separate two conditions that often get called an AC tune-up, but they are not the same job. A system that still cools but runs through long cycles often needs maintenance. A thermostat set correctly while vents blow warm air, the breaker trips, or the outdoor unit stays silent points to a fault.

We handle both situations. We use the thermostat, return grille, supply vents, indoor air handler, and outdoor condenser to separate a dirty filter or drain problem from a failed electrical or refrigerant-related component.

A routine check can wait briefly if the system cools normally and there is no water, odor, or unusual sound. Warm air, a burning smell, water around the air handler, or a tripped breaker should not wait, because heat, moisture, and electrical faults can damage parts beyond the original issue.

Warm air and rattling

We hear several versions of the same complaint. The AC runs all day but the house will not cool. Air barely comes from a bedroom vent. The indoor unit makes a rattling or buzzing sound. Water drips near the air handler, or a musty smell comes from the return grille after the system starts.

We check each symptom at its source instead of treating every complaint as a filter issue. Weak airflow can start at a clogged filter, a dirty coil, or a blower problem. Rattling can come from a loose panel, fan blade, or motor. These faults can sound alike from the hallway, but they require different parts and different levels of work.

Condenser inspection visit

We inspect the thermostat, air filter, return grille, blower compartment, evaporator coil area, condensate drain, outdoor coil, disconnect, and electrical connections. We measure the supply-and-return temperature split, voltage, motor amp draw, and capacitor reading against the rating on the component. We check refrigerant pressures only when the system behavior points to a cooling problem that needs that test.

A standard maintenance inspection usually takes 45 to 90 minutes. We can clear an accessible drain, secure loose panels, tighten suitable electrical terminals, and replace the correct filter during the visit. A failed motor, damaged coil, obsolete control, or special-order capacitor may need another visit after the correct part is identified.

Filter age and attic access

The age and type of the equipment affect the work. A common filter size and an accessible outdoor condenser are simpler to inspect than an older air handler with a discontinued control or a media filter cabinet behind attic framing. The model and serial label help us identify components that may no longer be stocked locally.

Access also changes the scope. A condenser behind a locked gate, on a roof, or beside dense landscaping takes more setup than a unit with clear working space. A corroded disconnect, damaged wiring, or failed capacitor can add replacement work. A part that must be ordered, or a required building or property-management sign-off, can add coordination beyond the inspection itself.

Model plate and filter size

Before calling, find the model number on the metal plate of the outdoor condenser or indoor air handler. Check the filter size printed on the filter frame or cabinet door.

Tell us which room has weak airflow and whether the thermostat display is operating. Let us know if the system is running now, if water is near the air handler, and whether the attic, gate, or roof access is clear.

Call Austin Air Conditioning Company at (512) 318-9239; a clogged condensate drain can overflow and worsen water damage if maintenance waits.

Looking for something else? Try air conditioner installation or the home page.