We understand why homeowners lower the thermostat or replace a dirty air filter first. Those steps can help airflow, but they cannot seal a leak in the refrigerant circuit. A system may cool again for a short time after refrigerant is added, then lose capacity as the charge escapes.
We trace the loss to the coil, copper line set, service port, or fitting before restoring the charge. Refrigerant leak repair should not wait because low refrigerant can freeze the evaporator coil and force the compressor to run hotter.
Warm vents and hissing
We hear calls about air blowing warm from the vents, even though the thermostat is set correctly. Customers also report a hissing sound near the outdoor condenser or indoor air handler. Ice on the copper suction line is another common sign of a low refrigerant charge.
We also check oily residue around a brazed joint, service valve, or coil connection. A loose service-port core, a leaking evaporator coil, and a damaged line set can look similar from the thermostat. We identify the failed part because each fault needs a different repair and involves different materials.
Nitrogen pressure test
We inspect the condenser cabinet, evaporator coil, copper lines, Schrader cores, and service valves. We record suction and liquid pressures, line temperatures, superheat, and subcooling. A basic equipment check and electronic leak scan commonly takes 30 to 60 minutes.
We can pressure-test the circuit with nitrogen if an electronic detector does not pinpoint the leak. Accessible valve cores, caps, and brazed fittings can often be repaired during the same visit. A coil replacement or concealed line-set repair is usually booked separately. After a repair, we evacuate the system to 500 microns or the manufacturer target, confirm the vacuum holds, and charge by the data plate specification.
Evaporator access and coil age
The leak location changes the scope of the work. A service-port core at the outdoor condenser is easier to reach than an evaporator coil inside a tight attic air handler. A line set behind drywall, above a ceiling, or under insulation takes more investigation and repair access.
The age and availability of the coil also matter. Older equipment may use a coil or valve that must be ordered, rather than stocked. A seized service valve can add labor because the refrigerant circuit must be opened and restored correctly. Rooftop equipment, gated yards, and building approval can also add coordination before we reach the unit.
Model plate and line-set access
We ask customers to read the model and serial number from the outdoor condenser data plate, usually on a cabinet side panel. We also ask for the approximate age of the air conditioner. That helps us identify the refrigerant type and likely replacement parts.
We need to know which room has the air handler and whether the system is cooling at all right now. Let us know if the condenser, attic hatch, or line-set route has blocked access. A photo of the coil cabinet or service valves can help us prepare. Call Austin Air Conditioning Company at (512) 318-9239; waiting can ice the evaporator coil and overheat the compressor.
Looking for something else? Try air duct cleaning or the home page.