Skip to content
Austin Air Conditioning Company

701 Brazos St, Austin, TX 78701

Serving Austin · Rollingwood · West Lake Hills · Lost Creek

(512) 318-9239

Air Conditioner Repair in Austin, TX

We trace warm air, rattles, odors, and water around Austin AC systems.

Call (512) 318-9239 Ask a question

A furnace and its ductwork in the corner of a tidy utility room, with copper pipes running up to the ceiling and a shelving unit beside it

Warm air from a supply vent, a sharp electrical odor, or water below the indoor unit means something has changed in the system. We trace the fault from the thermostat to the outdoor condenser, rather than replacing a part based on the sound alone.

We do not advise leaving a system running if it is blowing warm air, tripping a breaker, or leaking from the cabinet. A stalled fan, failing capacitor, or blocked drain can put added strain on the compressor and electrical components.

Warm air and rattling

We hear that the AC is blowing warm air, keeps starting and stopping, makes a rattling or buzzing sound, or has stopped moving air from the vents. Warm air may point to a capacitor, contactor, compressor, fan motor, or refrigerant problem. A rattle can come from a loose panel, worn fan blade, or failing motor.

We also check reports of water under the air handler, a burning smell near the return grille, and a breaker that trips after the condenser starts. Those symptoms can seem similar from inside the house, but they involve different parts, labor, and repair paths once we inspect the unit.

Thermostat and condenser callout

We start the callout at the thermostat, air handler, electrical disconnect, and outdoor condenser. We measure voltage, capacitor microfarads, compressor and fan amperage, and refrigerant pressures against the equipment data plate and manufacturer charging information. We also inspect the condensate drain, contactor, wiring terminals, blower, and condenser fan.

Initial testing commonly takes 20 to 30 minutes. A stocked capacitor, contactor, drain component, or wiring repair can often be completed during the same visit, with many routine repairs taking one to two hours. A compressor, evaporator coil, or control board that needs ordering is scheduled for a return visit after we identify the correct part.

Capacitor age and unit access

The age and condition of the failed part affect the repair scope. A worn capacitor or contactor is usually more direct than a damaged motor, compressor, coil, or control board. Burned terminals and heat-damaged wire can add work because we need to repair the connection, not only replace the failed component.

Access also changes the work involved. A condenser behind a locked gate, on a roof, or in a tight side yard takes more setup than a clear ground-level unit. A corroded disconnect, an ordered part, or building approval for electrical work can also extend the repair beyond the first callout.

Model plate and thermostat

We ask for the model number from the data plate on the outdoor condenser or indoor cabinet. We also need to know which room has the warmest vents and what the thermostat display shows.

Tell us whether the outdoor fan, indoor blower, or both are running. Let us know about gate, attic, roof, or closet access before we arrive. Call us at (512) 318-9239; running a unit with a stalled fan can overheat the compressor.

Looking for something else? Try ac tune up or the home page.