Skip to content
Austin Air Conditioning Company

701 Brazos St, Austin, TX 78701

Serving Austin · Rollingwood · West Lake Hills · Lost Creek

(512) 318-9239

Air Conditioner Installation in Austin, TX

New AC system sizing and installation for Austin homes.

Call (512) 318-9239 Ask a question

A technician crouching at an outdoor condenser unit beside a house, his open tool bag on the grass next to him

A cooling system that runs all afternoon but leaves bedrooms warm can become a larger problem over a week. The thermostat stays set lower, the blower runs longer, and the outdoor unit may begin cycling off at the breaker. By the next hot stretch, the supply vents can deliver warm air or no air at all.

An aging condenser can also leave water around the indoor air handler as long run times load the condensate drain. Replacing a unit that is already losing cooling capacity is easier to plan before the compressor stops or the drain pan overflows. A planned installation can wait if the system cools reliably, but warm vents, repeated breaker trips, or water at the air handler should not wait because the failure can stop cooling and damage nearby finishes.

Warm vents and breaker trips

Customers often call because the AC is blowing warm air, the outside unit keeps clicking, or the breaker trips after the system starts. Others notice that the thermostat is set correctly but one room stays hot while the rest of the house cools.

Water near the air handler, ice on the refrigerant line, and a blower that runs without cool air are other common descriptions. These symptoms can come from equipment faults, airflow restrictions, electrical trouble, or a system that no longer makes sense to keep in service.

The sounds and temperature changes can seem similar from inside the house. They can lead to very different work and different costs once we inspect the condenser, air handler, controls, and duct connections.

Replacement system survey

We start the survey at the thermostat, then check the outdoor condenser, indoor coil or air handler, breaker, disconnect, and refrigerant line route. We record the model and serial plate, measure the equipment space, and check supply and return duct openings.

A straightforward survey often takes 30 to 60 minutes. We also look at the condenser pad, attic or closet access, drain routing, electrical service, and the room layout used to size the replacement equipment.

The survey, measurements, and equipment selection are usually handled during the visit. The installation is normally scheduled separately. A straightforward split-system changeout may take 4 to 8 hours, while duct changes, electrical work, or difficult attic access can extend the job.

Equipment size and attic access

System capacity and equipment configuration affect the scope. A replacement condenser and matching indoor coil may fit the existing location, while a different cabinet size can require changes at the return plenum, supply transitions, or drain connection.

Access also matters. A condenser beside a clear driveway is different from equipment in a tight attic, a closet behind finished walls, or a yard with a narrow gate. The condition of the line set, disconnect, breaker, and condenser pad can add materials or labor.

Permitting or inspection requirements can add steps where they apply. Equipment that must be ordered, electrical service that needs updating, and ductwork that cannot support the new system also move the final scope.

Model plate and closet access

Before calling, find the model number on the metal data plate of the outdoor unit or indoor air handler. A photo of that plate helps identify the equipment type and the matching components.

Let us know which rooms stay warm and whether the system is producing any cool air now. Mention if the air handler is in an attic, garage, closet, or crawlspace, and describe any gate, stairway, or hallway leading to it.

Tell us if water is collecting near the indoor unit or if the breaker has tripped. Call Austin Air Conditioning Company at (512) 318-9239 before a failing compressor leaves the supply vents warm through the next heat spell.

Looking for something else? Try refrigerant leak repair or the home page.